PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 10109450

Fuel loads in U.S. cities.

B Bush·G Anno·R McCoy·R Gaj·R D Small
View original source ↗Export metadata ↓

Abstract

Sources of burnable material within U.S. cities are analyzed. Based on a detailed evaluation of construction practices, storage of burnable contents, building function and layout, and density of buildings in city districts, we derive urban fuel load densities in terms of land use type and geographic location. Residential building fuel loads vary regionally from 123 to 150 kg m-2; nonresidential building classes have loads from 39 to 273 kg m-2. The results indicate that average U.S. urban area fuel loads range from 14 to 21 kg m-2.

Explore related subjects

Construction MaterialsData CollectionEvaluation Studies as TopicFacility Design and ConstructionFiresHospitals, UrbanHousingUnited StatesJournal ArticleResearch Support, U.S. Gov't, Non-P.H.S.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B Bush, G Anno, R McCoy, R Gaj, R D Small. 1991. Fuel loads in U.S. cities.. https://doi.org/10.1007/bf01039525

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2026

Unconfined compressive strength prediction for the ordinary Portland cement-steel slag-silica fume ternary system based on response surface methodology.

This research was undertaken to address environmental concerns associated with industrial solid waste and to reduce cement consumption in geotechnical engineering. It specifically investigates the feasibility of using steel slag (SS) and silica fume (SF) as partial substitutes for ordinary Portland cement (OPC) in soil stabilization. The effects of SS, SF, OPC, and initial moisture content on the unconfined compressive strength (UCS) of stabilized soil were investigated through single-factor experiments and response surface methodology (RSM). The results show that SS and SF can synergistically enhance the strength of stabilized soil, although their interaction effect was not statistically significant within the investigated ranges. Compared with soil stabilized solely with OPC, the addition of 18 % SS and 10 % SF reduced OPC consumption by 3 % without compromising strength. Microstructural and compositional analyses further revealed that SS mainly supplied calcium- and silica-bearing components, while SF provided highly reactive silica and micro-filling effects, jointly promoting hydration reactions and improving the compactness of the stabilized soil matrix. As a result, more hydration products were formed in the OPC/SS/SF-stabilized soil than in the OPC-stabilized soil, which contributed to pore filling and strength enhancement. This study provides useful guidance for the sustainable utilization of industrial solid waste and the low-carbon development of soil stabilization materials.

Construction Materials↗
PubMed2006

Evaluation of the radioactivity of the pre-dominant gamma emitters in components used at high-energy proton accelerator facilities.

At a high-energy, high-intensity proton accelerator facility, the accelerator components inside the beam-line tunnel and the concrete wall of the tunnel are activated due to beam loss during operation. During maintenance work inside the tunnel, radiation emitted from these activated materials can cause exposure to radiation workers. In this study, the relation between the surface dose rate of activated materials and the induced radioactivity was considered, and an evaluation of the major radioactivity using the surface dose rate was made. It has been revealed that (22)Na in Al samples and (54)Mn in Fe samples, (60)Co and (54)Mn in Fe samples, and (60)Co in Fe and Cu samples are principal residual radionuclides after a few hundred days of cooling about a few years of cooling and approximately 10 y of cooling, respectively.

Construction Materials↗