PubMed · 10802567
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
A G de Castro, J Lapinski, A Tunnacliffe. 2000. Anhydrobiotic engineering.. https://doi.org/10.1038/75237
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Direct sample introduction (DSI) or "dirty sample injection" is a rapid, rugged, and inexpensive approach to large volume injection in gas chromatography (GC) for semivolatile analytes such as pesticides. DSI of complex samples such as eggs requires a very selective detection technique, such as tandem mass spectrometry (MS-MS), to determine the analytes among the many semivolatile matrix components that also appear. In DSI, the nonvolatile matrix components that normally would contaminate the GC system in traditional injection methods remain in a disposable microvial, which is removed after every injection. For example, 3 microg of nonvolatile residue typically remained in the microvial after an injection of egg extract using the DSI method. This analytical procedure involves the following: (i) weighing 10 g of egg in a centrifuge tube and adding 2 g of NaCl and 19.3 mL of acetonitrile (MeCN); (ii) blending for 1 min using a probe blender; (iii) centrifuging for 10 min; and (iv) analyzing 10 microL (5 mg of egg equivalent) of the extract using DSI/GC/MS-MS. No sample cleanup or solvent evaporation steps were required to achieve quantitative and confirmatory results with <10 ng/g detection limits for 25 of 43 tested pesticides from several chemical classes. The remaining pesticides gave higher detection limits due to poor fragmentation characteristics in electron impact ionization and/or degradation. Analysis of eggs incurred with chlorpyrifos-methyl showed a similar trend in the results as a more traditional approach.
Turkey produces about 80% of the total hazelnut crop of the world. About 75% of the production are exported. In Turkey hazelnuts are traditionally sun dried, and may be subject to mold growth and subsequent mycotoxin formation due to prolonged drying time under humid and rainy weather conditions. Drying hazelnuts in a reasonable time after harvest is necessary for mycotoxin-free, high-quality products. In general, nuts and cereals contaminated by the toxins pose a potential hazard not only to the people of the producer countries, but also to people of the importing countries, if they should be regarded as safe by inefficient sampling plans, therefore preventing toxin formation actually benefits very large populations. Deterioration and health hazards associated with toxin contaminated hazelnuts and other nuts and cereals have similar causes and consequences; therefore, deterioration of the nuts and cereals in storage has been reviewed by considering as many grains and nuts as possible, then special reference was made to hazelnuts. Proper preharvest practices followed by proper drying and safe storage reduces the hazards associated with contamination by the toxins. This article reviews the pre- and post-harvest practices, and the grain- and nut-drying systems required for toxin-free products. Because drying is the major unit operation involving this process, the drying systems and the mathematical models required for their design is also discussed.
This paper reports how water stress correlates with changes in hydraulic conductivity of stems, leaf midrib, and whole leaves of Prunus laurocerasus. Water stress caused cavitation-induced dysfunction in vessels of P. laurocerasus. Cavitation was detected acoustically by counts of ultrasonic acoustic emissions and by the loss of hydraulic conductivity measured by a vacuum chamber method. Stems and midribs were approximately equally vulnerable to cavitations. Although midribs suffered a 70% loss of hydraulic conductance at leaf water potentials of -1.5 MPa, there was less than a 10% loss of hydraulic conductance in whole leaves. Cutting and sealing the midrib 20 mm from the leaf base caused only a 30% loss of conduction of the whole leaf. A high-pressure flow meter was used to measure conductance of whole leaves and as the leaf was progressively cut back from tip to base. These data were fitted to a model of hydraulic conductance of leaves that explained the above results, i.e. redundancy in hydraulic pathways whereby water can flow around embolized regions in the leaf, makes whole leaves relatively insensitive to significant changes in conductance of the midrib. The onset of cavitation events in P. laurocerasus leaves correlated with the onset of stomatal closure as found recently in studies of other species in our laboratory.