PubMed Health⌕ Search

PubMed · 11379057

Mapping 137Cs deposition: data validation methods and data interpretation.

Abstract

The "Atlas of caesium deposition on Europe after the Chernobyl accident" was prepared within the framework of the Joint Study Project 6 (JSP6) of the collaborative programme on the consequences of the Chernobyl accident between the European Commission and the Ministries responsible for Chernobyl affairs in Belarus, Russia and Ukraine. The radiological data provided by scientific institutes and competent authorities of more than 30 European countries were integrated into an information platform. Data validation and intercomparison were therefore essential before the interpretation of the deposition with the help of isoline maps prepared with a geographic information system (GIS) could be done. The data validation was a two-step procedure: after performing a primary logical consistency check, other techniques based on spatial statistics were used to outline uncertain data. The purpose of this paper is to present these validation methods and to discuss the advantages and constraints of these techniques. Rather than trying to improve the techniques of spatial data analysis, suggestions are made on how an adaptation of the sampling information could improve the final result.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

G Dubois, M De Cort. 2001. Mapping 137Cs deposition: data validation methods and data interpretation.. https://doi.org/10.1016/s0265-931x(00)00136-3

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

137Cs and 40K soil-to-plant relationship in a seminatural grassland of the Giulia Alps, Italy.

To examine the soil-to-plant transfer of 137Cs and 40K, we performed a study based on sampling of natural soil and plants from an alpine pasture site situated in the Giulia Alps, Italy, during July 1997. High 137Cs activity was present in the upper most soil layer, and decreased one order of magnitude at a depth of 10 cm. An opposite gradient was observed for 40K. Simultaneous sampling of soil and plant material was performed in order to analyse transfer factor (TF) values. In spite of homogeneous 137Cs activities in soil, grass samples showed a high variability. A negative correlation was detected between 40K- and 137Cs-activities in plants. TF values for 137Cs were highly variable, thus suggesting that this parameter would be independent of 137Cs soil activity. Lower variability was observed for 40K TFs values. Our results suggest that TFs are highly variable parameters that appear to be independent on radionuclide soil activity. Because soil and plant characteristics strongly affect TF values, caution is necessary when TF values are used as the sole parameter to predict radionuclide uptake by plants in semi-natural ecosystems.

Cesium Radioisotopes↗

Accounting for the depth distribution of 137Cs in on-line mobile gamma spectrometry through primary and forward-scattered photons.

Stationary and mobile field gamma spectrometry is a useful tool for rapid estimation of environmental radioactivity inventories on and in the ground. A weak point however, is that the depth distribution of the activity in the ground must be known in order to calculate the true activity per unit area or unit mass from an observed photon fluence rate. A promising method for converting incoming spectral data into both true activity content and depth distribution in real time is the peak-to-valley method, which is based on an analysis of the ratio between count rates from primary and forward-scattered photons. In this study the peak-to-valley method was adapted to car-borne mobile gamma spectrometry, where the depth distribution of (137)Cs is fitted to a Lorenz function. Results from field experiments with a large HPGe detector, utilising point sources at different depths, are presented. It was found that the method can be useful for mobile measurements with a measuring time of 5-10 min for activity concentrations of about 100 kBq.m(-2) or higher, resulting in an uncertainty in the estimate of the true activity of about 50%.

Cesium Radioisotopes↗

A 'weighted' 137Cs inventory calculation of Reservoir 11, Mayak P.A., Russia with the novel use of remotely sensed information and sample data in a GIS.

The objective of this study was to make a robust 137Cs inventory calculation for Reservoir 11 in the Mayak Production Associations industrial cascade of reservoirs. High resolution satellite photographs provided information about the original Techa River and floodplain environment before, during and also after Reservoir 11 was constructed. The images provided important clues about the old Techa River system and also showed the extent of the contaminated area. Sediment cores were sampled along a transect in Reservoir 11, and perpendicular to the Techa River in 1996. 13Cs contamination densities were in the range 344-4030 kBq m(-2) and appear to exhibit a strong dependence on relative position along the transect, with more central positions exhibiting the highest actual levels. The contamination densities derived from the seven cores were combined with (published) data from four core samples collected in a 1994 field campaign. Sample data and images were integrated in a geographical information system (GIS). The GIS aided in the definition of distinctive floodplain classes, the so-called sediment 'facies', area calculations and in the positioning of 1994 and 1996 sample profiles in the reservoir. The resulting inventory estimate for Reservoir 11, is a factor 4-10 lower than earlier calculations. Analysis of the uncertainty in the calculations has been carried out and provides support for the integrity of the new method.

Cesium Radioisotopes↗