Small scale model for CFD validation in DAF application.

J Hague; C T Ta; M J Biggs; J A Sattary

Home/Archive/PubMed

PubMed · 11394270

Small scale model for CFD validation in DAF application.

J Hague·C T Ta·M J Biggs·J A Sattary

View original source ↗Export metadata ↓

Abstract

A laboratory model is used to measure the generic flow patterns in dissolved air flotation (DAF). The Perspex model used in this study allows the use of laser Doppler velocimetry (LDV), a non-invasive, high-resolution (+/- 2 mm s-1) laser technique of flow velocity measurement. Measurement of flow velocity in the single-phase situation was first carried out. Air-saturated water was then supplied to the tank and measurements of bubble velocity in the two-phase system were made. Vertical flow re-circulation was observed in the flotation zone. In the bottom of the flotation zone (near the riser) secondary flow re-circulation was observed, but only in the two-phase system. Another phenomenon was the apparent movement of flow across the tank width, which may be due to lateral dispersion of the bubble cloud. Data from preliminary computational fluid dynamics (CFD) models were compared against this measured data in the case of the single-phase system. The CFD model incorporating a k-epsilon model of turbulence was found to give closer agreement with the measured data than the corresponding laminar flow model. The measured velocity data will be used to verify two-phase computational fluid dynamics (CFD) models of DAF.

Explore related subjects

Air Computer Simulation Solubility Water Purification Journal Article Validation Study

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

J Hague, C T Ta, M J Biggs, J A Sattary. 2001. Small scale model for CFD validation in DAF application.. https://pubmed.ncbi.nlm.nih.gov/11394270/

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2002

Absorbed dose to water based dosimetry versus air kerma based dosimetry for high-energy photon beams: an experimental study.

In recent years, a change has been proposed from air kerma based reference dosimetry to absorbed dose based reference dosimetry for all radiotherapy beams of ionizing radiation. In this paper, a dosimetry study is presented in which absorbed dose based dosimetry using recently developed formalisms was compared with air kerma based dosimetry using older formalisms. Three ionization chambers of each of three different types were calibrated in terms of absorbed dose to water and air kerma and sent to five hospitals. There, reference dosimetry with all the chambers was performed in a total of eight high-energy clinical photon beams. The selected chamber types were the NE2571, the PTW-30004 and the Wellhöfer-FC65G (previously Wellhöfer-IC70). Having a graphite wall, they exhibit a stable volume and the presence of an aluminium electrode ensures the robustness of these chambers. The data were analysed with the most important recommendations for clinical dosimetry: IAEA TRS-398, AAPM TG-51, IAEA TRS-277, NCS report-2 (presently recommended in Belgium) and AAPM TG-21. The necessary conversion factors were taken from those protocols, or calculated using the data in the different protocols if data for a chamber type are lacking. Polarity corrections were within 0.1% for all chambers in all beams. Recombination corrections were consistent with theoretical predictions, did not vary within a chamber type and only slightly between different chamber types. The maximum chamber-to-chamber variations of the dose obtained with the different formalisms within the same chamber type were between 0.2% and 0.6% for the NE2571, between 0.2% and 0.6% for the PTW-30004 and 0.1% and 0.3% for the Wellhöfer-FC65G for the different beams. The absorbed dose results for the NE2571 and Wellhöfer-FC65G chambers were in good agreement for all beams and all formalisms. The PTW-30004 chambers gave a small but systematically higher result compared to the result for the NE2571 chambers (on the average 0.1% for IAEA TRS-277, 0.3% for NCS report-2 and AAPM TG-21 and 0.4% for IAEA TRS-398 and AAPM TG-51). Within the air kerma based protocols, the results obtained with the TG-21 protocol were 0.4-0.8% higher mainly due to the differences in the data used. Both absorbed dose to water based formalisms resulted in consistent values within 0.3%. The change from old to new formalisms is discussed together with the traceability of calibration factors obtained at the primary absorbed dose and air kerma standards in the reference beams (60Co). For the particular situation in Belgium (calibrations at the Laboratory for Standard Dosimetry of Ghent) the change amounts to 0.1-0.6%. This is similar to the magnitude of the change determined in other countries.

Air↗

PubMed2002

Glacial meltwater dynamics in coastal waters west of the Antarctic peninsula.

The annual advance and retreat of sea ice has been considered a major physical determinant of spatial and temporal changes in the structure of the Antarctic coastal marine ecosystem. However, the role of glacial meltwater on the hydrography of the Antarctic Peninsula ecosystem has been largely ignored, and the resulting biological effects have only been considered within a few kilometers from shore. Through several lines of evidence collected in conjunction with the Palmer Station Long-Term Ecological Research Project, we show that the freshening and warming of the coastal surface water over the summer months is influenced not solely by sea ice melt, as suggested by the literature, but largely by the influx of glacial meltwater. Moreover, the seasonal variability in the amount and extent of the glacial meltwater plume plays a critical role in the functioning of the biota by influencing the physical dynamics of the water (e.g., water column stratification, nearshore turbidity). From nearly a decade of observations (1991-1999), the presence of surface meltwater is correlated not only to phytoplankton blooms nearshore, but spatially over 100 km offshore. The amount of meltwater will also have important secondary effects on the ecosystem by influencing the timing of sea ice formation. Because air temperatures are statistically increasing along the Antarctic Peninsula region, the presence of glacial meltwater is likely to become more prevalent in these surface waters and continue to play an ever-increasing role in driving this fragile ecosystem.

Air↗

PubMed2002

Partition coefficients for the trihalomethanes among blood, urine, water, milk and air.

Chloroform, bromodichloromethane, chlorodibromomethane, and bromoform comprise the trihalomethanes, a group of widespread and mildly lipophilic compounds that result from water chlorination and other sources. Many animal studies show the chronic toxicity and carcinogenicity of these compounds, and recent work has demonstrated the importance of both ingestion and inhalation exposure pathways. This study presents partition coefficients describing the equilibrium among biological compartments (air, water, blood, milk, urine) for the four THMs based on results of headspace gas chromatographic analyses performed under equilibrium conditions and at 37 degrees C. The calculated partition coefficients ranged from 2.92 to 4.14 for blood/water, 1.54-2.85 for milk/blood, and 3.41-4.93 for blood/urine, with the lowest being chloroform and the highest being bromoform. Both human and cow milk were tested, with similar results. The available samples of human milk may not fully account for differences in lipid content and possibly other factors that affect estimates of partition coefficients. Simultaneous measurements of milk and blood in exposed individuals are suggested to confirm laboratory results. Partition coefficients are predicted using the octanol-air partition coefficient, also measured in this study, and the octanol-water partition coefficient. Results are similar to literature estimates for liquid/air partitioning of chloroform and chlorodibromomethane, but they differ from predictions based on hydrophobicity and lipid content. High correlations between the derived partitioned coefficients and the molecular structure (number of Br atoms) and physical properties (molecular weight and boiling point) are found for these analogous chemicals. In humans, THMs are both stored and metabolized with relatively rapid clearance rates. The derived partition coefficients can help to interpret results of biological monitoring and predict the potential for the accumulation and transfer of chemicals, specifically by the application of physiologically-based pharmacokinetic models. THM exposures to potentially susceptible populations, e.g. nursing infants, can be predicted using either such models.

Air↗