PubMed · 11443781
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R J Galeone. First, do no harm.. https://pubmed.ncbi.nlm.nih.gov/11443781/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Pressurized liquid extraction using the accelerated solvent extractor (Dionex ASE 200) has been evaluated for the determination of mono-, di- and tributyltin (MBT, DBT, and TBT, respectively) in PACS-2 certified reference material. A double-enriched spike containing 119Sn-enriched MBT and TBT and 118Sn-enriched DBT allowed for the simultaneous determination of the three butyltin species and the factors governing species interconversion. The stability of the spike was evaluated by reverse isotope dilution experiments covering more than one year with satisfactory results. Quantitative recoveries using ASE for TBT and DBT were obtained at temperatures above 110 degrees C. The effect of the extraction time and number of static cycles was evaluated. Results suggest that extraction efficiency was quantitative with extraction times as low as 10 min for all butyltin species at 110 degrees C. Decomposition reactions were only detected at the higher temperatures assayed (140 and 175 degrees C) and that was only for the degradation of DBT to MBT (approximately 4%). The results found for MBT were approximately 25% higher than the certified value for the PACS-2 sediment reference material in agreement with previous results obtained by ultrasonic and microwave assisted extraction.
Our previous measurements of the temperature dependencies of Henry's law constants of 26 polychlorinated biphenyls (PCBs) showed a well-defined linear relationship between the enthalpy and the entropy of phase change. Within a homologue group, the Henry's law constants converged to a common value at a specific isoequilibrium temperature. We use this relationship to model the temperature dependencies of the Henry's law constants of the remaining PCB congeners. By using experimentally measured Henry's law constants at 11 degrees C for 61 PCB congeners described in this paper combined with the isoequilibrium temperatures from our previous measurements of Henry's law constants of 26 PCB congeners, we have derived an empirical relationship between the enthalpies and the entropies of phase change for these additional PCB congeners. A systematic variation in the enthalpies and entropies of phase change was found to be partially dependent on the chlorine number and substitution patterns on the biphenyl rings, allowing further estimation of the temperature dependence of Henry's law constants for the remaining 122 PCB congeners. The enthalpies of phase change for all 209 PCB congeners ranged between 10 and 169 kJ mol(-1), where the enthalpies of phase change decreased as the number of ortho chlorine substitutions on the biphenyl rings increased within homologue groups. These data are used to predict the temperature dependence of Henry's law constants for all 209 PCB congeners.
Pressurized liquid extraction (PLE) is a fully automated extraction technique for isolation of analytes from solid samples. This technique combines elevated temperature and pressure of liquid solvents during the extraction process. In this study the efficiency of a PLE system for the isolation of wide range of analytes (polychlorinated biphenyls and organic pesticides from sediments under different pressure and temperature conditions) was investigated. The temperature 100 degrees C and pressure 6.9 MPa (1000 p.s.i.; 1 p.s.i.=6894.76 Pa) were found to be the most efficient from all investigated conditions. Using these PLE parameters, the average recoveries for most of the analytes were in the range 80-105% and relative standard deviation was usually under 15%. The conditions of determination of analytes in the extracts using GC-MS were established. Some problems occurring during the analysis of real samples, such as coelution of analytes, were established. The influence of internal standard addition on the final analysis results was determined.