PubMed Health⌕ Search

PubMed · 12710472

Alternative procedures for molt induction: practical aspects.

Abstract

Shortening daylight (to 10.5 to 11 h/d) slightly reduced the rest period (the interval between last egg and first clutch), whereas feeding a low-protein diet during the 22-d period following 8 d of feed withdrawal (FW) (recovery period) markedly extended it. Feed withdrawal accompanied by a short-daylight regime and a long recovery period led to the best postmolt production. However, production per hen housed during the whole experimental period was only slightly increased. Thus, a long rest period may mask the positive effects of short daylight and recovery diet. At least 140 to 170 d were needed to enable the molted hens to compensate for the loss of eggs during the rest period. Therefore, under certain economic conditions, rearing of nonmolting hens for 640 to 700 d should be an economic consideration. Ten days of feeding of a diet containing 0.06% nicarbazin (NICR) arrested egg production and caused a 22-d rest period but not a typical molt. Few variables of production or shell quality were improved by NICR but to a lesser extent than by FW or Zn feeding. Five days of feeding on a high-Zn diet (20 g Zn/kg; HZn) improved postmolt performances similarly to FW. Ten days of feeding on a modest-Zn (2.8 g Zn/kg), low-Ca, and low-P diet (Zn-CaP) affected postmolt performances inconsistently. In one out of two trials (trial 2), the effects of Zn-CaP were similar to those of FW or HZn; in the other (trial 3), the effects were less pronounced, more time was required for egg arrest, and more eggs were laid occasionally during the rest period. In trial 2, only the Zn-CaP diet was accompanied by short daylight. In both trials, feed intake during the induction period was only slightly reduced. Zn feeding increased the yolk Zn content slightly in eggs laid during the induction period and at the onset of production. In trial 2, only Zn-CaP markedly increased yolk Zn of eggs laid during the first 5 d of production.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

A Bar, V Razaphkovsky, D Shinder, E Vax. 2003. Alternative procedures for molt induction: practical aspects.. https://doi.org/10.1093/ps%2F82.4.543

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Assay and purity control of tetracycline, chlortetracycline and oxytetracycline in animal feeds and premixes by TLC densitometry with fluorescence detection.

Methods using TLC densitometry with fluorescence detection are described for the assay and purity control of tetracycline (TC), chlortetracycline (CTC), and oxytetracycline (OTC) in animal feeds and premixes. With a silica gel layer previously sprayed with 10% (m/v) sodium EDTA solution adjusted to pH 8.0 or 9.0, all the major impurities were separated from the main components and from each other. The mobile phase consisted of dichloromethane, methanol, and water. After development, the plate was dipped in a 30% (v/v) solution of liquid paraffin in hexane. Quantitation was realized by fluorescence densitometry at 400 nm. The limit of quantitation (LOQ) for tetracycline impurities is 0.8 microg/g, corresponding to 0.2% of the label claimed tetracycline (400 microg/g). The LOQ for impurities of tetracycline and chlortetracycline in premixes is 0.2% of the label-claimed TC (40 mg/g) and CTC (200 or 400 mg/g). The LOQ for impurities of oxytetracycline in a premix is 0.1% of the label claimed OTC (100 mg/g).

Animal Feed↗

Rapid pesticide analysis, in post-harvest plants used as animal feed, by low-pressure gas chromatography-tandem mass spectrometry.

A wide range of pesticides used to control pests in vegetables have been determined in agricultural plant waste from beans, watermelons, and melons grown in greenhouses located in a predominantly agricultural area in Southeast Spain (Almería). Analysis of the pesticides was carried out by low-pressure gas chromatography (LP-GC) with mass spectrometry in tandem (MS-MS) mode, after extraction of the lyophilized samples with dichloromethane. The influence of the sample matrix on the analysis was avoided by use of matrix-matched standards. Linearity, detection limit ( LOD), quantitation limit ( LOQ), recovery, and precision for each pesticide were calculated. The most frequently encountered pesticides were endosulfan (>73% of the analyzed samples) and buprofezin (>55% of the samples), followed by cypermethrin, pirimifos-methyl, bifentrin, and chlorpyrifos (>30% of the samples). The pesticide found at the highest concentration level was endosulfan (223.33 mg kg(-1)) in a watermelon sample.

Animal Feed↗

Feedstuffs as a vehicle of cattle exposure to Escherichia coli O157:H7 and Salmonella enterica.

Feed has been reported as a vehicle for transmission of Salmonella enterica in cattle and several lines of evidence suggest that feed can be a vehicle for transmitting Escherichia coli O157:H7 as well. To show whether microbial contamination of feeds could contribute to the populations of S. enterica and E. coli O157:H7 on a farm, we compared isolates from feed samples to bovine fecal isolates from the same farm using pulsed-field gel electrophoresis (PFGE). Four of 2365 component feed samples (0.2%) and 1 of 226 feed mill samples (0.4%) were positive for E. coli O157:H7. Twenty of 2405 (0.8%) component feed samples and none of 226 feed mill samples were positive for Salmonella. PFGE profiles from E. coli O157:H7 isolated from a component feed sample closely resembled that from a fecal isolate collected later from the same farm, and a similar observation was made of a Salmonella Tyhpimurium isolate from component feed on another farm. There were indistinguishable PFGE profiles from component feed Salmonella Tyhpimurium DT104 isolates and fecal isolates from the same farm. These results provide evidence for a role of cattle feed in transmission of E. coli O157:H7; S. enterica; cattle-bacteria.

Animal Feed↗