Imaging dislocations in ice.

Abstract

Three techniques have been used to study dislocations in ice: etch pitting-replication, transmission electron microscopy, and X-ray topography (XT). It is shown that, because ice is a weak absorber of X-rays and can be produced with a low dislocation density, allowing relatively thick specimens to be studied, the most useful technique is XT. The observations that have been made with conventional XT are briefly outlined. However, the introduction of high-intensity synchrotron radiation, with its concomitant short exposure times, showed that images obtained through conventional XT observations were of dislocations that had undergone recovery. The important dynamic observations and measurements that have been made using synchrotron X-ray topography are presented. Dynamic synchrotron X-ray topography observations of ice single crystals undergoing deformation in situ have shown that slip mainly occurs by the movement of screw and 60 degrees (1/3) [1120] dislocations on the basal plane, although non-basal slip by edge dislocations can also occur. The operation of Frank-Read and other dislocation multiplication sources have been clearly demonstrated and dislocation velocities have been measured. In contrast, in polycrystals, dislocation generation occurred at grain boundaries where there are stress concentrations before lattice dislocation generation mechanisms operate. Faulted dislocation loops have been determined to be mainly interstitial in both polycrystals and single crystals.