PubMed · 15710921
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Malvinder S Parmar. 2005-02-15. Treating C. difficile.. https://doi.org/10.1503/cmaj.1041195
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Methods development in chromatographic purification processes is a complex operation and has traditionally relied on trial and error approaches. The availability of a large number of commercial media, choice of different modes of chromatography, and diverse operating conditions contribute to the challenging task of accelerating methods development. In this paper, we describe a novel microtiter-plate based screening method to identify the appropriate sequence of chromatographic steps that result in high purities of bioproducts from their respective culture broths. Protein mixtures containing the bioproduct were loaded on aliquots of different chromatographic media in microtiter plates. Serial step elution of the proteins, in concert with bioproduct-specific assays, resulted in the identification of "active fractions" containing the bioproduct. The identification of a successful chromatographic step was based on the purity of the active fractions, which were then pooled and used as starting material for screening the next chromatographic dimension. This procedure was repeated across subsequent dimensions until single band purities of the protein were obtained. The sequence of chromatographic steps and the corresponding operating conditions identified from the screen were validated under scaled-up conditions. Various modes of chromatography including hydrophobic interaction, ion exchange (cation and anion exchange) and hydrophobic charge-induction chromatography (HCIC), and different operating conditions (pH, salt concentration and type, etc.) were employed in the screen. This approach was employed to determine the sequence of chromatographic steps for the purification of recombinant alpha-amylase from its cell-free culture broth. Recommendations from the screen resulted in single-band purity of the protein under scaled-up conditions. Similar results were observed for an scFv-beta-lactamase fusion protein. The use of a miniaturized screen enables the parallel screening of a wide variety of actual bioprocess media and conditions and represents a novel paradigm approach for the high-throughput process development of recombinant proteins.
In this paper, a simple method for the separation and determination of common inorganic anions by fast ion-exchange chromatography, using a modified short (25 mm x 4.6 mm) monolithic column, is reported. Coating the column with a cationic surfactant, cetylpyridinium chloride (CPC), the isocratic separation of some inorganic anions in minutes was possible, by direct or indirect UV detection. The coated column demonstrated excellent stability over time, even at a high flow-rate, giving retention times with an average relative standard deviation of 1.3% for over 10 consecutive runs. The developed column exhibited unusual selectivity for common anions, was successfully applied to the rapid analysis of inorganic anions of food samples, river water and factory waste water samples.
There is an increasing need to know the concentrations of chromium(III) and (VI) separately rather than only the total chromium content. A method is described for accomplishing this very quickly using only low-cost, portable equipment. Two small, resin-loaded extraction disks are placed one on top of the other in a plastic holder. Then a syringe containing the aqueous sample is attached to the holder and the sample is pushed through the disks. In a matter of seconds, all of the chromium(VI) is retained on the top anion-exchange disk and chromium(III) is extracted by the second cation-exchange disk. The concentrations on each disk are several hundredfold higher than they were in the original sample. The amounts of chromium(III) and (VI) extracted are measured directly on the surface of the respective disks by diffuse reflectance spectroscopy (DRS). Despite the low molar absorptivity of chromium(III) in aqueous solution, the concentration on the upper most layer on the extraction disk is high enough to permit the determination of chromium(III) in samples at the low mg/L range. Chromium(VI) can also be determined at low to sub-mg/L concentrations. A study of the cation-exchange disks was undertaken to compare the performance characteristics of disks containing sulfonated resins and those with iminodiacetate functionality. In addition, data are presented to show the effects of heating the iminodiacetate disks after the initial extraction. The disks were heated in hot water for 15-30 min to complete the slow complexation reaction on the surface.