PubMed · 16049259
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
J M Sikorski. 2005. Computer-assisted total knee replacement.. https://doi.org/10.1302/0301-620x.87b8.16557
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
We retrospectively reviewed the experience of a large international multi-centre study of primary total knee arthroplasty with mobile bearing design and modifications of the tibial component to allow for bicruciate preservation, posterior cruciate retention, or sacrifice. Twenty-seven surgeons performed 4,743 total knee replacements between 1981 and 1997. Implants inserted were 324 that retained both cruciate ligaments, 2,165 that retained the posterior cruciate, and 2,254 that sacrificed both cruciates. The patella was resurfaced in 2,838 and unresurfaced in 1,905. With failure defined as revision or reoperation for any reason, the overall survivorship was 79% at 16 years' follow-up. Revision occurred in 259 (5.4%) knees out of the entire cohort. The risk adjusted rates of failure were higher in females, younger patients, osteoarthritis, post-traumatic arthritis, and in patients who had a meniscal bearing prosthesis or patellar resurfacing. The most common cause of revision was bearing-related issues including chronic instability, bearing subluxation, bearing dislocation, or bearing wear in 2.3%.
BACKGROUND: Adequate and intensive rehabilitation is an important requirement for successful Total Knee Arthroplasty. The primary focus of early rehabilitation is ambulation of patients and regaining range of motion in the knee. Although research suggests that Continuous Passive Motion should be implemented in the first rehabilitation phase following surgery, there is substantial debate about the duration of each session and the total period of CPM application and. A Cochrane review on this topic concluded that short-term use of CPM leads to greater short-term range of motion. It also suggested, however, that future research should concentrate on the treatment period during which CPM should be administered. METHODS: In a randomised controlled trial we intend to investigate the efficacy of prolonged use of a continuous passive motion (CPM) device in the home situation as an adjunct to standardised physical therapy. The experimental treatment is compared to standardised physical therapy, in patients with osteoarthritis of the knee undergoing Total Knee Arthroplasty (TKA). Efficacy will be assessed in terms of faster improvements in range of motion and functional recovery. Seventy patients with knee osteoarthritis undergoing TKA and experiencing early postoperative flexion impairment (less than 80 degrees of knee flexion at the time of discharge) will be randomised over two treatment groups, a usual care group and an experimental group. The experimental group will receive CPM + physiotherapy for 17 consecutive days after surgery, whereas the usual care group will receive the same treatment during the in-hospital phase (i.e. about four days), followed by physical therapy alone (usual care) in the first two weeks after hospital discharge. From 18 days to three months after discharge, both groups will receive standardised PT. The primary focus of rehabilitation will be functional recovery (e.g. ambulation) and regaining range of motion (ROM) in the knee. DISCUSSION: Because restricted knee ROM affects functional activities, knee ROM and knee function are regarded as the primary indicators of successful TKA. Potential effects of the intervention under study include rapid return of knee flexion accompanied by earlier return to functional activities of daily life. If patients benefit significantly from prolonged CPM use, this treatment should be added to the standard PT treatment at home. We expect the additional home CPM programme to be more effective than the usual physiotherapy programme, resulting in a difference in ROM of at least 5 degrees , 17 days after surgery. This clinically important difference, with a possible flexion ROM of about 100 degrees , is expected to lead to better functioning in activities of daily life, like walking, and earlier ability to cycle. These advantages should result in earlier and increasing independence.
The goal of the study was to simultaneously obtain accurate kinematic and kinetic data from a total knee arthroplasty (TKA) during level walking, by coupling force plate data with the kinematics of TKA measured by a movable video-fluoroscopic system. Kinematic and kinetic information of a TKA is crucial for the improvement of implant designs and for the increased longevity of the implant components. Instrumented gait analysis, with skin mounted marker tracking and force plates, is a well-established method for the acquisition of kinematic and kinetic data of TKA in vivo and for non-invasive estimation of joint function. However, resultant moments at the knee joint are inaccurate with this method, due to skin movement artifacts. Video-fluoroscopy reduces these inaccuracies by means of the direct tracking of the implant components with X-ray. However this measuring technique carries disadvantages: it provides only kinematic data, and the image intensifier covers a limited field of view. This paper presents a newly developed measuring technique, which enables a more accurate resultant moments calculation for level walking than could be achieved by conventional instrumented gait analysis.