PubMed Health⌕ Search

PubMed · 17156245

Methylene blue for parathyroid localisation.

Abstract

The source did not provide an abstract. Follow the original record for more information.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

I R Appadurai, D Scott-Coombes. 2007. Methylene blue for parathyroid localisation.. https://doi.org/10.1111/j.1365-2044.2006.04920.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Microstructure design of nanoporous TiO2 photoelectrodes for dye-sensitized solar cell modules.

The optimization of dye-sensitized solar cells, especially the design of nanoporous TiO2 film microstructure, is an urgent problem for high efficiency and future commercial applications. However, up to now, little attention has been focused on the design of nanoporous TiO2 microstructure for a high efficiency of dye-sensitized solar cell modules. The optimization and design of TiO2 photoelectrode microstructure are discussed in this paper. TiO2 photoelectrodes with three different layers, including layers of small pore size films, larger pore size films, and light-scattering particles on the conducting glass with the desirable thickness, were designed and investigated. Moreover, the photovoltaic properties showed that the different porosities, pore size distribution, and BET surface area of each layer have a dramatic influence on short-circuit current, open-circuit voltage, and fill factor of the modules. The optimization and design of TiO2 photoelectrode microstructure contribute a high efficiency of DSC modules. The photoelectric conversion efficiency around 6% with 15 x 20 cm2 modules under illumination of simulated AM1.5 sunlight (100 mW/cm2) and 40 x 60 cm2 panels with the same performance tested outdoor have been achieved by our group.

Coloring Agents↗

Early aggregation in prion peptide nanostructures investigated by nonlinear and ultrafast time-resolved fluorescence spectroscopy.

We report the characterization of early aggregates in the self-assembly of prion peptides using nonlinear and ultrafast time-resolved fluorescence spectroscopy. The dye-labeled peptide and dye/peptide guest-host systems were used to demonstrate the feasibility of the new approach. By measuring the two-photon absorption cross-section, small aggregates of the dye labeled peptide were characterized. Ultrafast time-resolved fluorescence anisotropy spectroscopy reveals the packing state (microenvironment) of the probes to be tightly associated with aggregates and associated with aggregation progression of the peptides. Fluorescence intensity decay shows a correlation with growth of aggregates having a high level of structured beta-sheet content. A new binding ligand Cascade Yellow shows promise for beta-sheet recognition of prion peptide nanostructures. These findings may have implications for in vivo studies of neurotoxic aggregates targeting with fluorescence markers. Also, these results may provide insight into molecular design of peptide-based nanomaterials.

Coloring Agents↗

Photophysics of an indigo derivative (keto and leuco structures) with singular properties.

Spectral and photophysical properties of the indigo derivative Cibalackrot in keto and reduced (leuco) forms were studied by absorption spectra, fluorescence and pulse radiolysis and compared with the structurally similar indigo. With the keto form of this dye, fluorescence (phiF = 0.76) and intersystem crossing (phiT = 0.11) are dominant, whereas with indigo, efficient internal conversion (phiIC = 0.99) is observed, probably involving proton transfer through intramolecular hydrogen bonds. With Cibalackrot, this pathway is blocked, supporting the above model for indigo. With the reduced form of Cibalackrot, more than 98% of the absorbed quanta are dissipated through S1 approximately --> S0 internal conversion, which contrasts with leuco-indigo, where fluorescence (phiF = 0.35), internal conversion (phiIC = 0.53) and intersystem crossing (phiT = 0.125) are found to be competitive. In addition, a synthetic precursor of Cibalackrot (preCiba) was also investigated. This has a rigid molecular structure (with a moiety identical to Cibalackrot and the other to indigo), but intra- or intermolecular proton transfer is allowed between adjacent carbonyl and N-H groups. With this precursor in its keto structure the photophysical parameters are generally very close to those of the keto form of indigo, and different from those of Cibalackrot. A more detailed investigation of the time-decay profiles of preCiba in dioxane (and with added water and D2O) has shown that these follow biexponential laws with a shorter component of 14-25 ps, which appears associated with a risetime at longer wavelength emissions (and to a positive preexponential at shorter emission wavelengths) and a longer lived (decay) component of 104-130 ps. In the steady-state spectra of preCiba, the variation with temperature reveals a blue shift of the emission maxima, which is interpreted as the presence (simultaneous emission) of two species (keto and enol) in the excited state. Indigo and deuterated indigo are also found to present a similar behavior. The overall data are interpreted as to be due to an excited-state process involving the proton transfer between keto and enol forms. Rate constants with values of 7 x 10(10) s-1 for preCiba and 1.6 x 10(11) s-1 for deuterated indigo were obtained. This inverse isotope effect is justified on the basis of the proposed model for proton-transfer excited-state deactivation.

Coloring Agents↗