PubMed Health⌕ Search

PubMed · 3500943

Basic flow structure in saccular aneurysms: a flow visualization study.

Abstract

Basic flow patterns were investigated in a set of glass aneurysm models by means of flow visualization methods. Dye injection and streaming double refraction were used to visualize flow. The circulation inside lateral aneurysms arising at a 90 degree angle from a straight parent conduit could not be visualized by the dye-injection technique but could be demonstrated by streaming double refraction. The inflow was seen to arise from the downstream lip of the orifice and to project to the dome of the aneurysm. Backflow to the parent conduit took place along the walls of the aneurysm. In aneurysms located at bifurcations, flow characteristics depended on the geometry of the bifurcation and the flow ratio between the branches. Relatively little intra-aneurysmal flow was demonstrated in side branch-related aneurysms arising distal to an asymmetric 90 degrees bifurcation of the type encountered at the junction of the internal carotid and posterior communicating arteries. Stagnation of flow at the neck and little intra-aneurysmal circulation were found with terminal aneurysms of the basilar bifurcation type if the outflow through the branches was symmetric. With asymmetric outflow, however, or if the axis of the aneurysm did not coincide with that of the afferent vessel, an active rotation developed in these aneurysms. The size of the aneurysm had no influence on the basic pattern of intra-aneurysmal circulation. The use of pulsatile perfusion did not significantly alter the basic flow patterns observed with steady flow. Locally disturbed laminar flow was observed in certain models at physiological Reynold's numbers, but there were no signs of fully developed turbulence.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

H J Steiger, A Poll, D Liepsch, H J Reulen. 1987. Basic flow structure in saccular aneurysms: a flow visualization study.. https://doi.org/10.1007/bf02058520

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Microstructure design of nanoporous TiO2 photoelectrodes for dye-sensitized solar cell modules.

The optimization of dye-sensitized solar cells, especially the design of nanoporous TiO2 film microstructure, is an urgent problem for high efficiency and future commercial applications. However, up to now, little attention has been focused on the design of nanoporous TiO2 microstructure for a high efficiency of dye-sensitized solar cell modules. The optimization and design of TiO2 photoelectrode microstructure are discussed in this paper. TiO2 photoelectrodes with three different layers, including layers of small pore size films, larger pore size films, and light-scattering particles on the conducting glass with the desirable thickness, were designed and investigated. Moreover, the photovoltaic properties showed that the different porosities, pore size distribution, and BET surface area of each layer have a dramatic influence on short-circuit current, open-circuit voltage, and fill factor of the modules. The optimization and design of TiO2 photoelectrode microstructure contribute a high efficiency of DSC modules. The photoelectric conversion efficiency around 6% with 15 x 20 cm2 modules under illumination of simulated AM1.5 sunlight (100 mW/cm2) and 40 x 60 cm2 panels with the same performance tested outdoor have been achieved by our group.

Coloring Agents↗

Early aggregation in prion peptide nanostructures investigated by nonlinear and ultrafast time-resolved fluorescence spectroscopy.

We report the characterization of early aggregates in the self-assembly of prion peptides using nonlinear and ultrafast time-resolved fluorescence spectroscopy. The dye-labeled peptide and dye/peptide guest-host systems were used to demonstrate the feasibility of the new approach. By measuring the two-photon absorption cross-section, small aggregates of the dye labeled peptide were characterized. Ultrafast time-resolved fluorescence anisotropy spectroscopy reveals the packing state (microenvironment) of the probes to be tightly associated with aggregates and associated with aggregation progression of the peptides. Fluorescence intensity decay shows a correlation with growth of aggregates having a high level of structured beta-sheet content. A new binding ligand Cascade Yellow shows promise for beta-sheet recognition of prion peptide nanostructures. These findings may have implications for in vivo studies of neurotoxic aggregates targeting with fluorescence markers. Also, these results may provide insight into molecular design of peptide-based nanomaterials.

Coloring Agents↗