PubMed · 5743548
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
J Parsons, M L Polk, W T Beher. 1968. X-ray diffraction powderd data for steroids: supplement IX.. https://pubmed.ncbi.nlm.nih.gov/5743548/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The purpose of this work was to investigate the effect of punch speed on the compaction properties of pharmaceutical powders; in particular, to separate out differences between the effect of the compression and decompression events. Tablets were prepared using an integrated compaction research system. Various "sawtooth" punch profiles were followed to compare the effects of different punch speeds on the crushing strength of the resulting tablets. The loading and unloading speeds were varied independently of one another. In general, when the compression speed was equal to the decompression speed, the tablet crushing strength was observed to decrease as the punch velocity increased. When the compression speed was greater than or less than the decompression speed, the results varied, depending on the material undergoing compaction. Reduction of the unloading speed from 300 to 10 mm/sec for pregelatinized starch and microcrystalline cellulose produced a significant increase in crushing strength, whereas no significant increase in crushing strength was observed until the loading speed was reduced to 10 mm/sec. Reduction of the unloading speed had a similar effect on the direct compression (DC) ibuprofen, however, even greater improvement in the crushing strength was observed when the loading speed was reduced. No improvement in the DC acetaminophen tablets was observed when the unloading speed was reduced, however, a significant increase in crushing strength was produced when the rate of loading was reduced. This work showed that the strength of tablets can be improved and some tableting problems such as capping can be minimized or prevented by modifying the rates of loading/unloading.
Most of the pharmaceutical processes involved in the manufacturing of so lid dosage forms are connected with powder flow properties, at least for some of the intermediate steps. Powder flow characteristics are commonl y investigated by various measurements, such as handling angles, tap tes ting, shear cell measurements, etc. All these approaches allow the calc ulation of indices characterising powder flowability. Unfortunately, th ese methodologies are highly product consuming, which is a limitation in the first steps of a novel drug development, when only a small amount of product is available. The use of mercury porosimetry to evaluate compre ssibility and flow properties of powders could be a new and alternative approach to obtain insight in the rheological properties of granular med ium by the interpretation of the first part of programs (low pressures) . We have developed such an evaluation and compared the results obtaine d with those given by tap testing and shear cell measurements, applied t o four excipients for direct tabletting and three different drugs. Merc ury porosimetry turned out to be a sensitive technique, able to providequantitative information about powder flow properties, complemen ted by an evaluation of particles micro porosity and size distribution, in a single step. These characterisations are obtained with only approx imately 250mg of bulk powder compared to high quantities ( >100g) needed for other methods.
This communication reports on the correlation between extrusion forces and sphere characteristics. Dicalcium phosphate dihydrate, alpha-lactose monohydrate and anhydrous beta-lactose were models for respectively an insoluble, a medium soluble and a highly soluble drug and were used to produce spheres. Phase diagrams for ternary mixtures consisting of microcrystalline cellulose, water and a third excipient were constructed. The region where good spheres were obtained correlated well with the area of extrusion forces between 630 and 1260 N. This correlation was seen for the insoluble, the medium and the highly soluble products.