PubMed HealthSearch

PubMed · 6345737

Immediate, provisional postextraction pontic placement.

Abstract

A rapid technique is described for placement of a temporary pontic to provide immediate esthetics after extraction of an anterior tooth. It requires no laboratory facilities, no natural tooth preparation, and uses only a few dental materials. Being functional and practical, it allows the patient time to seek further care from a general practitioner at a time convenient to them both. Additionally, the psychological distress associated with removal of an anterior tooth is minimized, if not eliminated. Because no natural teeth are involved with any dental preparations, further prosthetic treatment is not compromised. Addition of this technique to the surgeon's treatment regimen is cost effective, and it will improve the relationship between patient and surgeon.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

S G Short. 1983. Immediate, provisional postextraction pontic placement.. https://doi.org/10.1016/0278-2391(83)90137-4

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

In vitro fatigue fracture of an acrylic resin-based partial denture: an exploratory study.

In this study the fatigue life of heat-cured acrylic resin test specimens shaped as maxillary partial dentures was examined. Ten test specimens were prepared from polymethyl methacrylate and were tested by a constant force fatigue test at 150 N immersed in +37 degrees C water. The fatigue-fracture surfaces of the test specimens were compared with a one-bend fracture surface of the control specimen by scanning electron microscopy. The correlation coefficient between the number of loading cycles required to cause fatigue failure in the midline section was calculated as was the concentration of residual methyl methacrylate. Results revealed that the fatigue life of the test specimens varied greatly (483 x 10(3) +/- 371 x 10(3) cycles) and that the correlation between the number of loading cycles and the midline section was poor (r -0.455). The correlation coefficient between the number of loading cycles and the concentration of residual methyl methacrylate was r 0.476 and p > 0.5. The fatigue-fracture surface of the test specimens was smoother in texture on the tension side than on the one-bend fracture surface.

Denture Design