PubMed · 6960241
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R Garberoglio, S Bassa. [The transparent tooth].. https://pubmed.ncbi.nlm.nih.gov/6960241/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The purpose of this study was to measure intrapulpal temperature rise induced by two kinds of bleaching gels when the tooth was exposed to a variety of light-curing units and a diode laser in vitro. The root portions of 80 extracted intact human maxillary central incisors were sectioned with a carborundum disk approximately 2 mm below the cementoenamel junction perpendicular to the long axis of the teeth. Two bleaching agents containing heat-enhancing colorant was applied to the labial surface. Light-curing units used were a conventional halogen (40 s), a high-intensity halogen (30 s), a light-emitting diode unit (40 s), and a diode laser (15 s). The temperature rise was measured in the pulpal chamber with a J-type thermocouple wire that was connected to a data logger. Ten specimens were used for each system and bleaching-agent combination. Differences between the starting temperature and highest temperature reading were taken and the calculated temperature changes were averaged to determine the mean value in temperature rise. Temperature rise values were compared using two-way analysis of variance (ANOVA) at a preset alpha of 0.05. Temperature rise varied significantly depending on curing unit and diode laser used. The diode laser induced significantly higher temperature increases than any other curing unit (11.7 degrees C). The light-emitting diode unit produced the lowest temperature changes (6.0 degrees C); however, there were no statistically significant differences among the curing units and there were no statistically significant differences between bleaching agents. Light activation of bleaching materials with diode laser caused higher temperature changes as compared to other curing units and the temperature rise detected was viewed as critical for pulpal health.
Six iatrogenic dental borings were identified in four individuals of a Native American skeletal collection from an 18th and early 19th century Middle Columbia River burial site. The borings, all in maxillary first molars with severe dental attrition and secondary dentin, demonstrate striated walls and associated periapical alveolar lesions. An ethnographic review of the subsistence pattern during the burial period indicates a diet that is consistent in dental attrition with other riverine fisher-hunter-gathers. Histological changes of dental pulp tissue during the process of attrition may result in dental necrosis. Access into the pulp chamber is a technique used to drain necrotic fluid. A common Euro-American therapeutic dental practice of the 18th and 19th centuries for diseases of the pulp was dental extraction. Multiple dental borings indicate that the practice of molar drilling into the pulp chamber was an effective and independent technique used by the Wishram and Wasco people.
OBJECTIVE: The aim of this study was to determine the penetration depth of laser light in teeth for contact and noncontact probe tip. STUDY DESIGN: Fifty-one freshly extracted human mature maxillary and mandibular single rooted teeth were selected for the study. A laser Doppler flowmeter was used as a laser source. A digital camera was used to take pictures (with "night shot" mode in total darkness). When probe tip was in contact and when it was 1 mm away from the tooth, the depths of the areas illuminated in high and low density were measured. RESULTS: In contact probe, root was illuminated to 4.28 +/- 0.14 mm depth with high density and 13.27 +/- 0.27 mm depth with low density. In noncontact probe, 4.36 +/- 0.16 mm with high density and 13.28 +/- 0.30 mm with low density of illumination were seen on the root. Between contact and noncontact probe situations the difference was not statistically significant in the depth of illumination. On the other hand, in both groups the difference between areas illuminated in high and low density was statistically significant (P < .05). CONCLUSION: Contact or noncontact of the probe on tooth surface did not show any significant difference in light penetration. Besides, we think that, for the present, it is impossible to eliminate the contamination from periodontal tissues completely even if the necessary precautions (periodontal paste etc.) are taken.