PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 8155607

Effect of polyurethane surface chemistry on its lipid sorption behavior.

A Takahara·K Takahashi·T Kajiyama
View original source ↗Export metadata ↓

Abstract

The relationships among surface, bulk properties and lipid sorption behaviors of segmented polyurethanes (SPUs) with various polyol soft segments were investigated. The polyols used in this study were poly(ethylene oxide) (PEO), poly(tetramethylene oxide) (PTMO), and poly(dimethylsiloxane) (PDMS). The hard segment of these segmented polyurethanes was composed of 4,4'-diphenylmethane diisocyanate and 1,4-butanediol, present at 50 wt%. X-ray photoelectron spectroscopic (XPS) and dynamic contact angle measurements were carried out in order to analyze the surface chemical structure in the air- and water-equilibrated states. XPS revealed that in the air-equilibrated state, lower surface free energy components were enriched at the air-solid interface, whereas in the water-equilibrated state, higher surface free energy components were enriched at the water-solid interface. The change in environment from air to water induced the surface reorganization in order to minimize interfacial free energy. Lipid sorption behaviors of SPUs were investigated by means of infrared spectroscopy. Even after extensive rinsing of the surface, the amount of lipid present on the SPU surface was more than that calculated on the assumption that a monolayer covers the SPU surface. Therefore, the lipid was not only adsorbed on the surface of SPU but absorbed into SPU. The SPU with hydrophilic PEO sorbed larger amount of phospholipid compared with that with hydrophobic polyol such as PTMO and PDMS. Also, the competitive sorption behaviors of phospholipid and cholesterol from their mixed liposome solution were studied. The ratio of sorbed cholesterol to phospholipid increased with an increase in surface hydrophobicity owing to the hydrophobic nature of cholesterol.

Explore related subjects

AbsorptionAdsorptionAirBiocompatible MaterialsCholesterolDimethylpolysiloxanesGlycolsLipidsLiposomesPhospholipidsPolyethylene GlycolsPolymersPolyurethanesSiliconesSpectroscopy, Fourier Transform InfraredSurface PropertiesWaterComparative StudyJournal Article

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

A Takahara, K Takahashi, T Kajiyama. 1993. Effect of polyurethane surface chemistry on its lipid sorption behavior.. https://doi.org/10.1163/156856293x00285

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

Adsorption, absorption, and biological degradation of ammonia in different biofilter organic media.

A tailor-made apparatus called ammoniometer, which is a batch mode respirometer applied to the study of ammonia biodegradation in biofilter media, has been used to evaluate adsorption, absorption, and biodegradation in five different organic materials (compost, coconut fibre, bark, pruning wastes, and peat) obtained from full-scale biofilters in operation in several waste treatment plants. The results showed that absorption could be represented by a Henry's law linear equation, with values of the Henry coefficient significantly higher (from 1,866 to 15,320) than that of pure water (1,498). Adsorption data were successfully fitted to Langmuir and Freundlich isotherms and maximum adsorption capacity varies from 1.06 to 1.81 mg NH(3)/g dry media. Ammonia biodegradation rates for each organic material were also calculated. Biodegradation rates varied from 0.67 to 7.82 mg NH(3)/kg media/d depending on the material tested. The data obtained showed important differences in the behaviour of the biofilter organic media, which has important implications in the design and modelling of these systems.

Absorption↗
PubMed2007

The use of an oil absorber as a strategy to overcome starvation periods in degrading 1,2-dichloroethane in waste gas.

This work investigates the use of an oil absorber as an operational strategy in vapor phase bioreactors exposed to starvation periods, during the treatment of inhibitory pollutants. After being exposed to 1,2-dichloroethane (DCE) starvation periods, the response and stability of a combined oil-absorber-bioscrubber (OAB) system was compared to that of a bioscrubber only (BO) system. In the BO system, after a 5.2 days starvation period, the DCE removal efficiency was reduced to 12%, and 6 days were needed to recover the initial removal efficiency when the DCE feed resumed. The total organic discharged (TOD(DCE)) was 16,500 g(DCE) m(bioscrubber) (-3) after the DCE starvation. Biomass analysis performed using fluorescence in situ hybridisation (FISH) showed that the microbial activity was significantly reduced during the starvation period and that 5 days were needed to recover the initial activity, after the re-introduction of DCE. In contrast, the performance of the OAB system was stable during 5.2 days of DCE starvation. The DCE removal efficiency was not affected when the DCE feed resumed and the TOD(DCE) was significantly reduced to 2,850 g(DCE) m(bioscrubber) (-3). During starvation, the activity of the microbial culture in the OAB system showed a substantially lower decrease than in the BO system and recovered almost immediately the initial activity after the re-introduction of DCE. Additionally, a mathematical model describing the performance of the OAB system was developed. The results of this study show that the OAB system can effectively sustain the biological treatment of waste gas during starvation periods of inhibitory pollutants.

Absorption↗
PubMed2007

Pterin pigment granules are responsible for both broadband light scattering and wavelength selective absorption in the wing scales of pierid butterflies.

A small but growing literature indicates that many animal colours are produced by combinations of structural and pigmentary mechanisms. We investigated one such complex colour phenotype: the highly chromatic wing colours of pierid butterflies including oranges, yellows and patterns which appear white to the human eye, but strongly absorb the ultraviolet (UV) wavelengths visible to butterflies. Pierids produce these bright colours using wing scales that contain collections of minute granules. However, to date, no work has directly characterized the molecular composition or optical properties of these granules. We present results that indicate these granules contain pterin pigments. We also find that pterin granules increase light reflection from single wing scales, such that wing scales containing denser granule arrays reflect more light than those with less dense granule collections. As male wing scales contain more pterin granules than those of females, the sexual dichromatism found in many pierid species can be explained by differences in wing scale pterin deposition. Additionally, the colour pattern elements produced by these pterins are known to be important during mating interactions in a number of pierid species. Therefore, we discuss the potential relevance of our results within the framework of sexual selection and colour signal evolution.

Absorption↗