PubMed · 14275885
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
G C SAUER. 1965. FLUBBER DERMATITIS.. https://doi.org/10.1001/archderm.1965.01600110051011
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
In the present study, three different methods for packing of 3 microm PBD-ZrO2 particles in 0.5 mm i.d. glass-lined stainless steel columns have been examined. The two first methods were based on a traditional downstream high-pressure technique using tetrachloromethane (Method I) or aqueous Triton X-100 (Method II) as slurry solvents, while Method III was an upstream high-pressure flocculating method with stirring, using isopropanol both as the slurry and packing solvent. Method I was found to be superior in terms of efficiency, producing 0.5 mm i.d. x 10 cm columns with almost 90,000 plates m(-1) for toluene (R.S.D. = 8.7%, n = 3), using a slurry concentration of 600 mg ml(-1), ACN-water (50:50 (v/v)) as the packing solvent and a packing pressure of 650 bars. For Method I, the slurry concentration, column i.d., column length and initial packing pressure were found to have a significant effect on column efficiency. Finally, the long-term temperature stability of the prepared columns was investigated. In isothermal mode, using ACN-20 mM phosphate buffer, pH 7 (50:50 (v/v)) as the mobile phase, the columns were found to be stable for at least 3,000 void volumes at 100 degrees C. At this temperature, the solute efficiencies changed about 5-18% and the retention factors changed about 6-8%. In temperature programming mode (not exceeding 100 degrees C), on the other hand, a rapid decrease in both column efficiency and retention factors was observed. However, when the columns were packed as initially described, ramped up and down from 50 to 100 degrees C for 48 h and refilled, fairly stable columns with acceptable efficiencies were obtained. Although not fully regaining their initial efficiency after refilling, the solute efficiencies changed about 19-28% (32-37%) and the retention factors changed about 4-5% (13-17%) after running 3,000 (25,000) void volumes or 500 (3,900) temperature programs.
In the present study poly(isoprene-block-ethylene oxide), PI-b-PEO, block copolymers are used to structure iron oxide and silica precursors into reverse mesophases, which upon dissolution of the organic matrix lead to well-defined nanoparticles of spheres, cylinders, and plates based on the original structure of the mesophase prepared. The hybrid mesophases with sphere, cylinder, and lamellar morphologies containing the inorganic components in the minority phases are characterized through a combination of small-angle X-ray scattering (SAXS), transmission electron microscopy (TEM), scanning transmission electron microscopy (STEM), and electron energy loss spectroscopy (EELS). After heat treatments the respective nanoparticles on mica surfaces are characterized by scanning force microscopy (SFM). X-ray diffraction (XRD) and superconducting quantum interference device (SQUID) magnetometer measurements are performed to demonstrate that the heat treatment leads to the formation of a magnetic gamma-Fe2O3 crystalline phase within the amorphous aluminosilicate. The results pave the way to functional, i.e., magnetic nanoparticles where the size, shape, and iron oxide concentration can be controlled opening a range of possible applications.
Mitogen-activated protein kinase (MAPK) pathways transfer environmental signals into intracellular events such as proliferation and differentiation. Fungi utilize a specific pheromone-induced MAPK pathway to regulate conjugation, formation of an ascus, and entry into meiosis. We have previously identified a MAPK, PCM, from the fungal opportunist Pneumocystis, responsible for causing severe pneumonia in patients with AIDS. In order to gain insight into the function of PCM, we expressed it in Saccharomyces cerevisiae deficient in pheromone signaling and tested activation and inhibition of this MAPK pathway. PCM restored pheromone signaling in S. cerevisiae fus3Delta kss1Delta mutants with alpha-factor pheromone (six-fold increase) and was not activated by osmotic stress. Signaling through this pathway decreased 2.5-fold with 10 microM U0126, and was unaffected with SB203580. We evaluated the conditions for native PCM kinase activity isolated from Pneumocystis carinii organisms and found that 0.1 mM MgCl2, pH 6.5, temperature 30-35 degrees C, and 10 microM ATP were optimal. The activity of PCM is significantly elevated in P. carinii trophic forms compared to cysts, implicating a role for PCM in the life cycle transition of P. carinii from trophic forms to cysts.