PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 14705058

Lumped-element planar strip array (LPSA) for parallel MRI.

Ray F Lee·Christopher J Hardy·Daniel K Sodickson·Paul A Bottomley
View original source ↗Export metadata ↓

Abstract

The recently introduced planar strip array (PSA) can significantly reduce scan times in parallel MRI by enabling the utilization of a large number of RF strip detectors that are inherently decoupled, and are tuned by adjusting the strip length to integer multiples of a quarter-wavelength (lambda/4) in the presence of a ground plane and dielectric substrate. In addition, the more explicit spatial information embedded in the phase of the signals from the strip array is advantageous (compared to loop arrays) for limiting aliasing artifacts in parallel MRI. However, losses in the detector as its natural resonance frequency approaches the Larmor frequency (where the wavelength is long at 1.5 T) may limit the signal-to-noise ratio (SNR) of the PSA. Moreover, the PSA's inherent lambda/4 structure severely limits our ability to adjust detector geometry to optimize the performance for a specific organ system, as is done with loop coils. In this study we replaced the dielectric substrate with discrete capacitors, which resulted in both SNR improvement and a tunable lumped-element PSA (LPSA) whose dimensions can be optimized within broad constraints, for a given region of interest (ROI) and MRI frequency. A detailed theoretical analysis of the LPSA is presented, including its equivalent circuit, electromagnetic fields, SNR, and g-factor maps for parallel MRI. Two different decoupling schemes for the LPSA are described. A four-element LPSA prototype was built to test the theory with quantitative measurements on images obtained with parallel and conventional acquisition schemes.

Explore related subjects

Equipment DesignHumansLegMagnetic Resonance ImagingMathematicsModels, TheoreticalPhantoms, ImagingJournal ArticleResearch Support, U.S. Gov't, P.H.S.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Ray F Lee, Christopher J Hardy, Daniel K Sodickson, Paul A Bottomley. 2004. Lumped-element planar strip array (LPSA) for parallel MRI.. https://doi.org/10.1002/mrm.10667

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2006

Analog pixel array detectors.

X-ray pixel array detectors (PADs) are generally thought of as either digital photon counters (DPADs) or X-ray analog-integrating pixel array detectors (APADs). Experiences with APADs, which are especially well suited for X-ray imaging experiments where transient or high instantaneous flux events must be recorded, are reported. The design, characterization and experimental applications of several APAD designs developed at Cornell University are discussed. The simplest design is a ;flash' architecture, wherein successive integrated X-ray images, as short as several hundred nanoseconds in duration, are stored in the detector chips for later off-chip digitization. Radiography experiments using a prototype flash APAD are summarized. Another design has been implemented that combines flash capability with the ability to continuously stream X-ray images at slower (e.g. milliseconds) rates. Progress is described towards radiation-hardened APADs that can be tiled to cover a large area. A mixed-mode PAD, design by combining many of the attractive features of both APADs and DPADs, is also described.

Equipment Design↗
PubMed2006

Silicon avalanche photodiodes for direct detection of X-rays.

Silicon avalanche photodiodes (APDs) are discussed as fast X-ray detectors for synchrotron radiation. The emphasis is on ;direct' detection, where the X-ray is absorbed within the silicon APD itself, and, therefore, on use with medium-energy X-rays, <30 keV. The impact of APD structure on device performance is examined, and representative data from many different commercial devices are presented. Specific areas discussed include signal shapes, high-rate behavior, time resolution and pulse-height response. Data from several APD arrays are also presented, as is a detailed description of an integrated package system. Tables are included comparing commercially available devices, including arrays.

Equipment Design↗
PubMed2006

Are real-time displays of benefit in the singing studio? An exploratory study.

This article reports on an exploratory research project to evaluate the usefulness or otherwise of real-time visual feedback in the singing studio. The primary purpose of the work was not to optimize the technology for this application, but to work alongside teachers and students to study the impact of real-time visual feedback technology use on the students' learning experiences. An action research methodology was used to explore the benefit of real-time displays over an extended period. The experimental phase of the work was guided by a Liaison Panel of teachers and academics in the areas of singing, pedagogy, voice science, speech therapy, and linguistic science. Qualitative data were collected from eight students working with two professional singing teachers. The teachers and students acted as co-researchers under the action research paradigm. Teachers and students alike kept journals of their teaching and learning experiences. Singing lessons were observed regularly by the research team, coded for teacher and student behaviors, and all co-researchers were interviewed at the mid- and endpoint of the project. The use of technology had a positive impact on the learning process, and this is evidenced through case study data.

Equipment Design↗